What is Included?
Many of our customers wonder, what exactly is included with my Combi eco or eco plus kit?
Outside of the unit itself and CP Plus Display the following items are included to support your installation.
Exhaust Type and Ducting
Wall Flue with 24" Ducting (for installations located close to exterior wall)
Wall Flue with 52" Ducting (for installations located further to exterior wall)
coming soon! Roof Flue with 96" Ducting (For Roof exhaust installations in 8' or shorter vans)
Exterior Exhaust Cowl Vent
This is your Combi's connection to the outside world. You will need to drill a 3-1/4" or 83MM Hole on the side of your RV or trailer as per the instruction manual.
Exhaust Cowl Gasket
Exhaust Cowl Cover (Black)
Exhaust Inner Hose Clamps (2x)
Exhaust Outer Hose Clamps (2x)
Exhaust Cowl Screw kit (8x Philips Head Stainless Steel)
80MM Hose Clamps (2x)
These clamps are used to hold the Exhaust/Intake Hose out of harms way as per installation manual
Hot Water Push Lock Connector (10MM to 12MM)
This has a automatic air purge valve to make sure the boiler is full of water when in use
Air Purge Hose
Attaches to the Hot Water Adapter and is required to be directed outside the RV.
Cold Water Push Lock Connector (10MM to 12MM)
Cold and Hot Water 1/2" Adapter (2x)
Allows for you to use standard PEX or CTS 1/2" Lines with the 12MM Push Lock Connectors
Hot Water Pressure Safety Valve
This valve opens when the hot water side increases past 65psi. This is a safety features and requires to be routed outside of the RV or Trailer. Accepts a Standard 1/2 NPT thread and must be installed as per the installation manual
Hot Water Safety Valve Extension Hose
Used to route the water evacuated from the safety valve well below the floor of the RV.
Water Pressure Regulator
This must be installed so that any incoming water in your RV or Trailer is pressure regulated before it reaches the Combi as per installation manual. This units steps down high pressure pumps, or city water to 30PSI. Has two standard 1/2" NPT Threads.
Room Temperature Sensor
Must be installed as per installation manual, requires 25/64" or 10mm hole drilled. It is advised this is installed on a inside wall, and not a outside wall as the cold wall will affect readings.
Room Temperature Sensor Wiring Harness
Wiring Harness between Room Temperature Sensor and Combi. 13.1FT or 4M in length
CP Cable for Control Panel
Attaches between the CP Plus Display and the Combi Unit
CP Plus Display Wiring Lead
Provides 12V to the CP Plus Display
CP Plus Fuse Block
2amp Fuse block for the lead that provides +12V to the CP Plus Display
CP Plus Wall Plate Mount
CP Plus Wall Plate Screws (4x)
Used to Mount Wall Plate to the Wall
CP Plus to Wall Plate Screw (1x)
Hidden under the front button, this screw holds the CP Plus to the Wall Plate
Spade Connectors (2x)
Used to provide +12V power to the combi unit. Please use a 10A Fuse connected with 12 AWG Wire